Home > Clone/Bsp > Clone / Mod parts > Rocker arms >

Gage Roller Rockers
Gage Roller Rockers


 
: $200.00


Product Code: GAGE
Qty:

Description
 
The Rev Rockers are intended for use in the Honda or clone GX160 and GX200 motors.The push rod guide plate is NOT needed.

Installation :
  1. Install the Rev Rockers by placing Loctite on the rockershaft bolt. Thread the rocker shaft bolts into the cylinderhead and torque to 20 ft. lbs.
  2. Valve lash needs to be set with the piston at top dead center. Use a feeler gauge to set valve lash to .005”.
  3. With a ball peen hammer you need to clearance the valve cover. A small amount of clearance is needed for the lash adjustment nut.
  4. Start and run the motor for 2 to 3 minutes. Run the engine gently.
  5. Remove the valve cover and check lash. Repeat step 2 if the valve lash changed.
  6. Repeat this break in period until the valve lash consistently measures .005”.

Share your knowledge of this product. Be the first to write a review »